Form 43343320
Aug 2012 -25-
12.1) ATTACHING BURNER BOX ASSEMBLY
1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.
2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed
clips onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two
required) of the reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner
box assembly.
3. The heater can be mounted horizontally
horizontallyhorizontally
horizontally or at an angle of up to 45
4545
45 degrees
degreesdegrees
degrees maximum from horizontal.
When angle mounting, the burner
burnerburner
burner box unit must
mustmust
must be positioned upright
uprightupright
upright as shown below
Failure to install the
Failure to install the Failure to install the
Failure to install the
control box in an UPRIGHT position will VOID the manufacturer’s warranty
control box in an UPRIGHT position will VOID the manufacturer’s warrantycontrol box in an UPRIGHT position will VOID the manufacturer’s warranty
control box in an UPRIGHT position will VOID the manufacturer’s warranty.
..
.
Angle Mounting
Straight Tube Heaters
Burner
Box
Upright Position
Angle Mounting
U-Tube Heaters
Burner
Box
Upright Position
Reflector
1/4-20 Locknut
(QTY-3 per flange)
Mounting Flange
24 Hole for Aluminized Steel Tubes
6 Hole for Alumi-Therm Steel Tubes
Tube Flange
Gasket
Speed Clip
(QTY-4)
Optional
End
Reflector
Burner Box
Burner Box Suspension
Eye bolt
Turnbuckle
Failure to install the burner box
suspension chain will void
manufacturers warranty.
DO NOT lift burner or support its
weight using the TISS wire. It will
break under heavy load.
The burner box weighs 38 lbs. Use
caution when handling it.
To Next Page
Loading...
