SunStar SPS SERIES - BURNER BOX AND TISS SYSTEM CONNECTION

Form 43343320
-26- Aug 2012
12.2) CONNECTING THE TISS SYSTEM
Desc
DescDesc
Description:
ription:ription:
ription: The TISS
TISSTISS
TISS (Tube Integrity Safety System)
(Tube Integrity Safety System)(Tube Integrity Safety System)
(Tube Integrity Safety System) is designed to shut the main burner off in the event that a
burnout occurs in the first 10ft. section of firing tube. Note:
Note:Note:
Note: When replacing the firing tube a new TISS
TISSTISS
TISS wire
assembly PN 44176510 (
((
(spring
springspring
spring and spr
and sprand spr
and spring retainer clamp
ing retainer clamping retainer clamp
ing retainer clamp not included)
not included)not included)
not included) must also be installed.
Instructions
InstructionsInstructions
Instructions:
::
:
1. Make sure that the gap between the burner box and end of reflector is 3” and the reflector is securely
attached to the reflector support bracket. Make adjustments if necessary.
3 Gap (between
burner box and end
of reflector)
#10 x 1/2 Screws
must securely attach
reflector to the bracket
TISS Assembly.
S
tep 1
Failure to maintain 3 gap as shown will result in pre-mature TISS wire failure.
2. Un-roll the TISS
TISSTISS
TISS wire assembly from the spool. Be careful not to kink the wires.
Spool with TISS Wire
Assembly
Step
2