134
4. Click Ready.
“doUn” will appear on the LED of
OP.
The machine will change into sewing mode with the pattern number selected.
② Now you are ready to receive
from SSP.
③ For transmission, click “Bartack
direct transmission”under serial
communication tool bar to send
to SPS-1254.
If transmission is done successfully,
you will hear a beeping sound
and see “End”on the LED of OP.
If the design size is bigger than
256 byte and smaller than 512
byte, you will hear the beeping
sound twice because the size of
data transmission is 256 byte
each. So, your data will be
divided into two packets for
transmission and beeps will go
off twice.
For designs larger than this size,
the frequency of beeps will also
go up accordingly.
④ Press Reset.
The selected pattern number will
appear. Repeat number 3 and 4
to send designs for different
pattern numbers.
⑤ Press Select.
To Next Page
Loading...
