45
There are two ways to create sewing data based on configuration:
Normal Stitching Dialog and Zigzag Stitching Dialog.
The following figure shows the actually created sewing data to help you understand
for parameters.
① Configuration data should be previously created on
the edit range. (Please refer to “Creating Configur-
ation Data”above.)
② Select any of created configuration data. If several
configuration data exists as shown in the left figure,
the selected configuration data displays in blue and
the rest display in gray.
③ Click “Normal Stitching” in Sewing Tool Bar.
④ At this time, Regular Stitch Dialog is displayed.
Data can be inputted in two places: “Stitch Length
(pitch)”to set up the length of stitch to be created,
and “Sewing Speed”to adjust the sewing speed
at a user’s disposal. (Please refer to that Sewing
Speed is to be available.)
⑤ Upon “Ok”, you can find that sewing data with line
attributes has been created based on Normal line
configuration data as shown in the figure. ⑥
Repeat ②, ③, ④, and ⑤ above to create other
sewing data.
··
Normal Stitching
Stitch Length(pitch)
To Next Page
Loading...
