49
You can create Machine Stop Control Command
(Stop) and Clamp Inversion/Non-inversion Command
(Clamp Inversion) as described in Thread Trimming
Control Com-mand. Machine Stop Control Command
is displayed as “Stop”in blue, and Clamp Inversion
/Non-Inversion Command can be selected with two of
right/left modes. It is displayed with “Clamp-L/Clamp-
R”. The figure shows that all mechanical control
commands are created.
This is a command to delete the created mechanical control commands.
You can delete mechanical control commands with as described to delete one stitch
data. Click machine control delete command and click sewing data where to delete,
then the selected data is changed in blue. And click the right button to display a
message box that asks you to delete it. Like this, whenever you exe-cute machine
control commands, the message box is displayed. And a message that asks you
how to do is also displayed on the lower status bar. The order is as follows:
··
Macine Stop Control Command/ Clamp Inversion Command
··
Medchanical Control Command Deletion
① Click Delete Machine Control Command at
Machine Tool Bar prior to deleting it, then the sele-
cted button gets concaved.
② Use the mouse’s left button to click a sewing data
joint where there is a machine control command to
be deleted. The figure shows that the Thread
Trimming Command is selected. The selected joint
gets blue. (The figure uses the same pattern as
foresaid.)
③ Click the mouse’s right button to display Machine
Control Delete Dialog. It has two types of radio
buttons: “Specified”and “All”.
“Specified”to delete the current machine control
command, and “All”to delete all machine control
commands in the current edit range.
To Next Page
Loading...
