50
··
All Thread Trimming Command
② Place Mouse Point at the edit range and click its right button to display Insert
All Machine Control Dialog that asks you for thread trimming.
③ Click “OK”to delete the above dialog. There is no change of sewing data on the
screen.
④ Click Save Button on the upper-left of the menu. Save Dialog is displayed a few
seconds after floppy disk reading sound occurs. And the end of sewing data is
automatically trimmed. The following shows that Thread Trimming is automatically
added.
⑤ Write directory name and file name, then click
“Save”. When pressing the “Cancel”button in-
stead of the “Save”button, the created thread
trimming command does not disappear; it stays
effective.
① Click All Thread Trimming Command in Machine Tool Bar under the state that
machine command is created, then the selected button gets concaved.
This is to make you convenient. Thread is automatically trimmed at the end of the
connection of sewing data and jump, therefore you don’t need to input a thread
trimming command every end of sewing data. To apply this function, the current
work should be save. (It is recommended that you apply this function finally prior to
saving.) The order is as follows:
To Next Page
Loading...
