51
This function can program the devices connected to an output port upon punching.
In other words, during sewing, signals output from the selected output port can
activate the operation of a user device. Therefore, if you are not a trained and skilled
engineer, take extra caution in using the function.
Follow the steps below to use the function.
① Assume there is a square pattern design as below. This is an exercise aimed to
activate the linked pneumatic signals at Point A and Point B of the square.
··
User output port code
② Select the output port function button. When selected, the button
remains pressed. Select Point A as the desired output point.
When selected, the stitch point turns red.
A
B
To Next Page
Loading...
