53
④ The delay time can be set at the position before or
behind the selected output port. The delay time
can be set at the unit of 4ms, and the setting can
be done for before, behind, and before & behind.
However, the time delay setting is not indicated on
the screen.
FIRST : Set the delay time at the position just
before the output port is set.
LAST : Set the delay time at the position just
behind the output port is set.
BOTH : Set the delay time at the position before
and behind the output port is set.
In FIRST, set the delay time at 200ms. Then,
200ms of time delay occurs before Head ascends.
⑤ Set Head Down at Point B using the same method.
In LAST, set the time delay at 200ms.
The figure below shows the conditions applied when the output port is set.
H-ON
H-OFF
To Next Page
Loading...
