54
This function can program the devices connected to a chosen input port upon
punching. In other words, the selected input port waits until a signal is input from an
external device and the normal operation begins after the signal input. Therefore, if
you are not a trained and skilled engineer, take extra caution in using the function.
Follow the steps below to use the function.
① Assume that there is a square pattern design as below. When the input port setting was
made at Point A of the square, the sewing machine stops the sewing at Point A, and
when an external signal is input to the chosen input port, the sewing machine resumes
operation again.
··
Output Port Control Command
② Select the input port function button. When selected, it remains
pressed. Select the stitch point located at the desired place for
input as Point A. The selected stitch point turns red.
A
To Next Page
Loading...
