59
③ Press the right mouse button. When the button is
pressed, the output port setting dialogue window
appears at the same time. Select the output port
signal for setting.
Head Up/Down : User sets the head up/down.
Select Head-Up.
Time delay can be set at the unit of 4ms before,
behind, and before & behind the head-up/down.
But the time delay setting is not indicated on the
screen.
FIRST : Time delay is set at the position just
before the output port is set.
LAST : Time delay is set at the position just
behind the output port is set.
BOTH : Time delay is set at the position just
before and behind the output port is set.
In FIRST, set 200ms for time delay. It means
200ms of time delay occurs before the head
ascends.
The time delay can be set before and behind the position where Head Up/Down is set.
The purpose of giving time delay for Head-Up/Down is to give substantial time for the
head's move-up/move-down and thereby make the motion more accurate.
The head-up/down setting function is applicable to the C-series only.
This serves the same function as output port setting code OP5.4 as
explained previously.
To Next Page
Loading...
