61
This function let pressure foot moves up or down when user inserts a code into a
stitch data. It uses an output port that is linked with a pressure foot height control
device. In other words, a signal that is sent through the output port makes a
pressure foot moves up or down while punching.
Take extra care in using this function, if you are not a trained or skilled engineer.
Follow the steps below to use the function.
① Assume that there is a square pattern as bellow. This is an exercise aimed to control
pressure foot height at POINT A and POINT B of the square.
··
Pressure foot Control Command (for E-Series only)
B
② Press the “Pressure Foot Control Command” button. When the
button is selected, it becomes hollow. Click a stitch point “A” that
is desired position to control pressure foot height. The selected
point turns red.
A
B
A
To Next Page
Loading...
