95
③ Input the rotation angle of 30 degree to click
“OK”.
④ You can fine that the selected pattern has been
rotated.
If you apply rotation only with the selected sewing data and set the rotating
degree at 1°from computational error, the data will be distorted. In order
to prevent data distortion, generate the sewing data with the configuration
data as a base, then rotate the configuration data and re-generate the
sewing data for rotation.
··
Move
① Select configuration and sewing data to move.
② Select Move to display Move Dialog. The sel-
ected pattern is displayed to the whole range
with dotted lines as shown in the figure.
Move the selected configuration and sewing data.
The Move Dialog includes the following functions:
Parallel move of whole pattern : Move the whole
pattern completely.
Parallel move of Specified elements (range) :
Move just the selected configuration data or
sewing data.
X-axis : Input the unit to move into X-axis.
Y-axis : Input the unit to move into Y-axis.
③ Input 1 to X and Y axis each, and click “OK”.
④ You can find that the selected pattern has been
moved.
To Next Page
Loading...
