101
MACHINE SET
Press after selecting MACHINE SET and the following screen appears:
CUT NEEDLE is used when sewing materials are to be cut with a boring needle. REMEMBER that thread
breaks are not detected and trim functions are not performed on the needle bar designated as the CUT
NEEDLE.
LESSON: Designate the #6 needle bar as CUT NEEDLE
1. MACHINE SET
2. FRAME ORIGIN
3. FRAME LIMIT SET
Place the cursor on “2. CUT
NEEDLE” and press
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
When a cursor flickers on #11
needle bar, press “1”on numerical
keys to designate CUT NEEDLE.
At this time, the cursor
automatically moves to #2 needle
bar.
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
Make the cursor move to the #6
needle bar by pressing “0”key.
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
Designate CUT NEEDLE in the #6
needle bar by pressing “1” key
from the present cursor
To Next Page
Loading...
