Make sure that the outlet is not blocked to prevent damage to the unit.
The exhaust hose should not be bent.
Control panel
Low
Water Full
Dehumidify
POWER
MODE
FAN
TIMER
Cool
Fan
Water Full
Low
High
Timer
Sleep
¡ã
F
Hr
C
¡ã
1. On/Off Button 9. High/Low indicator
2. Mode Button 10. Full water indicator
3. Up/Down Button 11. Cooling mode indicator
4. Fan Button 12. Dehumidify mode indicator
5. Timer Button 13. Fan mode indicator
6. Display 14. Sleep mode indicator
7. Celsius/ Fahrenheit degree indicator 15. Remote control sensor location
8. Timer indicator
1. Once you plug in the unit, you will hear the start sound; the display shows the ambient temperature.The
unit is in the standby mode now.
2. ON/OFF button: press this button to start the unit or shut down the unit. Once you plug in the unit for
the first time, it starts in the cooling mode, with high fan speed and temperature of 24 (75 ).
3. MODE Button: Press this button to switch between cooling, fan and dehumidifying modes; the
corresponding mode indicator will illuminate.
Cooling mode: Press MODE button or COOL (remote control) to choose this mode. In this mode,
press Up/Down button to set suitable temperature. The temperature range is 17～30℃（62～ 86°F）.
One press makes the temperature rise or fall on 1℃ / 1°F.
Press Fan Button or High Low to choose suitable fan speed.
Press the up button and down button simultaneously to switch between the Fahrenheit degree and
Celsius degree. When the Celsius degree is displayed, the Celsius degree indicator illuminates.
Press Timer button and Down button together or Sleep to choose Sleep mode. Under this mode,
after the unit operates for 2 hours, the setting temperature raises on 1℃ (1°F) automatically. After
operating for another 2 hours, the setting temperature raises on 1℃ (1°F) again. After that, the
setting temperature won’t change. This sleep mode is recommended to you for the night to give you
good and sufficient sleep.
In the dehumidifying mode, if the ambient temperature ≥17℃, the compressor will start. Then, the
unit is controlled in the following manner: when the ambient temperature ≤15℃, the compressor
shuts down. When the ambient temperature rises to be ≥17℃, the compressor starts again. The
start/stop of the compressor meets the requirement for 3-minute protection time. The fan is forced to
To Next Page
Loading...
