To have a maximum safety the helmet must fit tightly
and be correctly and securely fastened, in order not to be able
to be taken off neither by pulling it nor by rotating it around
the head.
If it is too big, it may slide down over the eyes or turn
in a lateral direction due to movement during riding,
blocking the right visibility.
SHELL in three sizes (M, L and XL) hand made.
The new material is a mix of carbon and aramidic fabric.
INTERNAL POLYSTYRENE in three sizes (M, L and XL).
The special shape and construction in different density increases mechanical
resistance in the event of accidental shock.
SHIELD thermoformed froma flat sheet.
Each shield is a one-of-a-kind piece with unequalled optical features and mechanical resistance.
Thanks to this process, the face shield is anti scratch and anti fog and there is no need to use
additional lenses on the visor.
The D-RING RETENTION SYSTEM has been designed
and patented by Suomy.
Insert the free side of the strap in the rings. Pull the end until
the strap presses firmly against the jaw.
After this operation, it should not be possible to remove the
helmet. Verify that by grabbing it from the back and rotating
it to the front it cannot be removed and it is fixed to the head.
If the helmet tends to come off or rotates freely, tighten the
strap again until the right pressure is obtained and repeat test.
If after repeating the test you are not able to efficiently
tighten the retention system, do not use the helmet.
Only after checking the correct tension of the strap, fix the
free end locking it with the automatic stud to the release tab.
The automatic stud is necessary only to fix the free end of the strap to prevent it from
flapping while riding. Fixing the release button does not assure that the helmet is correctly in
position and properly fastened: the correct locking of the strap must be verified exclusively
following the above paragraphs.
To release the retention system, release the automatic stud button and pull the release tab to
loosen the closure. Slide out the free end of the strap from the «D Rings».
Use the release tab only to remove the helmet! Never release this tab while riding.
To Next Page
Loading...
