Suparule Systems Ltd., Suparule House, Lonsdale Road,National Technology Park, Limerick, Ireland.
Tel: +353.61.201030
Typical faults
Screen is blank
Unit does not measure
all wires
Incorrect readings
If the display shows
- - -.- - -
Do not hesitate to call SupaRule: +353.61.201030, if you have any technical queries, we will be pleased to help.
Check battery is inserted correctly.
< Open battery door on the bottom rear of the
unit.
< The battery is inserted with the terminals
inwards.
< The + and - symbols on the battery should
correspond with the + and - symbols on the
inside of the battery compartment.
Ensure CAL mode switch is on correct
position, i.e. WIRE for cable height
measurement, and WALL for horizontal
distance measurement.
< Ensure no walls or similar obstructions
within 2 meters either side of unit, as
reflections from these can interfere with
correct operation.
Ensure that horizontal distances between
wires are within the sonic beam.
his indicates a “poor target”, and normally
happens when the conductors are moving
due to wind, etc.
To Previous Page
Loading...