1. Please use the correct external power supply: The power type used by the product
must remain the same as the power indicated on the product's power label. If you do
not know which type to use, please contact your authorized service provider or your
local power company for help.
2. Select the correct voltage: If the voltage selector switch is provided, please make sure
that the voltage selector switch is set at the correct voltage you are using (115VAC or
230VAC).
3. Do not connect too much power to the socket (extension cord). The load rating of the
entire system should not exceed 80% of the line rating.
4. Keep the power supply away from moistened or dusty places.
5. Please avoid any area with high temperature(such as, Radiators, heaters, stoves, or
other products that produce high temperatures).
6. Please avoid any foreign body into the product. The notches and openings are
designed for heat dissipation and ventilation, do not block or cover.
7. Before wire connector installation, please check whether the metal has been oxidized
or loose conditions. Also beware if the metal shakes easily after connecting with the
hardware.
8. If it is regular to plug and install the joint, please beware if the metal has become
fatigued or wear and tear, and lead the metal to an excess contact area.
9. When inserting and removing the wire connector, please pay attention to the direction
of the plug and receptacle, correct and complete angle to avoid the bad connection.
10. Molex 4pin to PCI-E or SATA to PCI-E adapters are prohibited to use to power the
graphic card or CPU. If there is any problem resulting from client's mistakes or
inappropriate use, Super-Flower won't take any responsibility for the problem.
11. If there are any following conditions, please unplug the power cord from the socket
and contact your authorized service provider for repairing：
i. Power cord, extension cord or plug is damaged
ii. Liquid infiltrated the product or foreign body falls into the product
iii. The product becomes wet because of rain or immersed in water
iv. The product is dropped or damaged
v. Overheat warning message
If the power supply does not operate normally, please check with following steps:
1. Make sure the plug is properly inserted into the outlet.
2. Check the switch location shows the same input voltage as that of the outlet.
3. Check the peripheral or the floppy disc drive connector is correctly plugged.
4. Repeat the I/O several times, each in 5 seconds after the last attempt.
5. Check whether the computer components are compatible with regulation.
6. Check whether the case has any key stuck, or abnormal conditions.
7. If the problem remains the same after aforementioned checks, please return the
product to the retailer or dealer for service.
Do not open the top cover of power supply case!
Beware of the shell with sign to avoid electric shocks!
***Attention! To avoid electric shocks,
Non-authorized technical staff shall not make any action mentioned above!! ***
REMARKS:
EASY TROUBLESHOOTING :
To Previous Page
Loading...