Need help?Do you have a question about the Super Star S1100 and is the answer not in the manual?
General| Brand | Super Star |
|---|---|
| Model | S1100 |
| Category | Medical Equipment |
| Language | English |
User guidance for electromagnetic compatibility requirements.
Describes the primary components and appearance of the ventilator.
Details the physical arrangement and parts of the main unit.
Explains the operational logic and flow of the ventilator.
Details the structure and operation of the air compressor.
Explains the function and operation of the O2 and Air blender.
Details how to connect the gas supply to the ventilator.
Explains the procedure for connecting the oxygen supply.
Describes how to connect the air supply.
Explains the process of draining water from filters.
Details how to connect the breathing circuit to the ventilator.
Instructions for installing and connecting the exhalation valve.
Steps for installing and connecting the O2 sensor.
Guidance for installing the humidifier.
Instructions for installing the nebulizer.
Procedure for installing O2, CO2 monitors, and oximeter.
Guides on how to install and use the pressure regulator.
Steps to follow after completing the operation of the pressure regulator.
How to connect and use the AC power supply.
Information about the internal backup battery.
Describes the switchover process between AC and battery power.
What happens when the backup battery voltage is low.
Procedures for charging the backup battery.
Guidelines for discharging the backup battery.
Instructions for replacing the backup battery.
Procedures for replacing fuses in the machine.
When to perform checks before operation.
Steps for performing a system check on the ventilator.
How to check power supply alarms.
Procedure for checking the gas supply.
How to verify the ventilator's ventilation functions.
Steps to test the alarm functions of the ventilator.
General procedures for operating the ventilator.
Identifies and explains the ventilator's control panel and keys.
Steps to start the ventilator and enter its initial state.
How to choose between VTL and VTH ventilation modes.
Guide to setting ventilation modes and operational parameters.
How to reset alarm parameters on the ventilator.
Instructions for resetting the system settings.
Procedure to start and operate in IPPV mode.
Procedure to start and operate in PCV mode.
Procedure to start and operate in A/C mode.
Procedure to start and operate in SIMV mode.
Procedure to start and operate in SPONT/CPAP mode.
Procedure to start and operate in PSV mode.
Procedure to start and operate in MANU mode.
How to set up and use the Apnoea function.
How to set up and use the SIGH function.
Steps to activate and use the nebulizer function.
How to use the audio paused function for alarms.
How to activate and deactivate the key lock function.
Procedure for calibrating the oxygen concentration.
How to adjust and operate the Air and O2 blender.
How to operate the air compressor if equipped.
Steps to complete the operation and shut down the machine.
Lists of alarms, their causes, and warnings.
Provides meanings for various hint icons and symbols.
Procedures for cleaning parts that contact the patient.
Initial cleaning and disinfection steps before first use.
Guidelines for cleaning reusable components.
Specifies the lifespan and replacement intervals for reusable parts.
How to clean the external surface of the ventilator.
Daily cleaning routine before starting operations.
Disinfection procedures after each patient use.
How to reassemble parts after cleaning and disinfection.
Daily or as-needed maintenance tasks.
Monthly or as-needed maintenance tasks.
Maintenance tasks required every 3 months or 1000 hours.
Maintenance tasks for over 1500 hours or 6 months of operation.
Annual maintenance or after 2500 hours of operation.
Maintenance tasks for every two years or 5000 hours.
Proper disposal methods for batteries and O2 sensors.
How to dispose of electronic and plastic components.
Procedures for disposing of the entire medical equipment.
Details alarms, their priority, setting ranges, and alarming ways.
Specifies the operating and storage environmental requirements.
Classifies the ventilator based on IEC standards.
Details the gas source requirements and pressure specifications.
Electrical specifications for voltage, frequency, and power.
Lists the types and ratings of fuses used in the device.
Performance metrics of the breathing system under various conditions.
Table showing pressure and flow characteristics of the breathing circuit.
Performance data for the humidifier.
Range and error for setting breath frequency.
Range and error for setting inhalation time.
Range and error for setting tidal volume.
Range and error for setting minute ventilation.
Range and error for setting PEEP.
Range and error for setting CPAP.
Range and error for setting continuous flow.
Range and error for setting pressure trigger.
Range and error for setting pressure control.
Range and error for setting pressure support.
Range and error for setting flow trigger.
Range and error for setting O2 concentration.
Range and error for setting holding time.
Range for setting Sigh function.
Range for setting Apnoea ventilation.
Maximum inspiratory flow rate specification.
Pressure output specification for the air compressor.
Flow rate specification for the air compressor.
Peak flow rate specification for the air compressor.
Dew point temperature specification for the air compressor.
Alarm temperature specification for the air compressor.
Noise level specification for the air compressor.
Standards for monitoring equipment compatibility.
Standards for humidifier compatibility.
Details of the main power failure alarm.
Information on the low voltage alarm for the backup battery.
Details of the gas failure and no tidal volume alarm.
Information on high and low Minute Ventilation alarms.
Information on high and low Peak Airway Pressure alarms.
How pressure limits are managed during alarms.
Details of the continuous pressure alarm.
Information on O2 concentration alarms.
Details of the Apnoea alarm and mode transitions.
How to pause alarm sounds.
Information about the safety valve pressure.
Precautions and steps for moving the ventilator.
Environmental conditions for storing the ventilator.
Guidelines for packing and transporting the ventilator.
Environmental conditions during transportation.
General notes on service, warranty, and product lifespan.
Diagram showing the installation of the ventilator with compressor.
Diagram showing the installation of the ventilator without compressor.
Diagram detailing the assembly of the ventilator stand and components.
To Next Page