Part # Replacement Parts
System Cartridge Qty
Maintenance
The only routine maintenance your Supera® Water Filtration System should ever require is periodic filter cartridge changes
or replacement sump O-rings. Filter changes are necessary for optimum performance of your foodservice equipment. If the
system sizing recommendations have been followed the Supera® Water Filtration System is designed to provide a six (6)
month filter replacement interval on most tap water.
Filter Change Frequency
Several situations will mandate filter changes. Complete filter sets should be changed when any of the following apply:
• Six (6) Months have passed since unit installation or previous filter change.
• Reduced water flow.
• Pressure gauge needle enters the red zone or drops below pressure required for equipment operation.
If filter change frequency is less than 6 months due to pressure drop, it may be necessary to add additional prefiltration or
evaluate system sizing recommendations.
NOTE: Testing was performed under standard
laboratory conditions, actual performance may
vary. It is recommended that you have your
water supply tested to determine your actual
water treatment requirements.
For further information regarding Supera®
Water Filtration Systems visit the NSF website
at www.NSF.org.
Models IF-C8F10, IF-C15F20, IFP-C15F20,
IF-C24F40 & IFP-C24F40 Tested and Certified
by NSF International against NSF / ANSI
Standard 42 for the reduction of:
Standard 42: Aesthetic Effects
Chlorine
Taste and Odor
Particulate Reduction: Class I
Supera®, LLC | www.SuperaCo.com
PO Box 4547 | Englewood | Colorado | 80155
service@superaco.com
Customer Care: 866-953-3288
IF-C8F10
IF-C15F20
IFP-C15F20
IF-C24F40
IFP-C24F40
RIF-5
RIF-10
RIF-10
SPRF-10
RIF-10
RIF-10
SPRF-10
1
1
1
1
2
1
2
600-10051 10” Filter Sump
600-99003 O-Ring
600-10060 20” Filter Sump
520-12055 Valve, Inlet Ball
530-20019 Gauge, Pressure
600-99007 Wrench, Housing
600-99205 Pressure Relief Button Kit
160-52910 (Optional) Flush Valve Kit 1/2”
To Previous Page
Loading...