Supermicro SBA-7121M-T1 - Page 5

3
SBA-7121M-T1 RAID Setup Procedure
3. From the SATA Configuration menu screen select the NVIDIA RAID FUNCTION
setting, hit <E
NTER> to open its options and select ENABLE.
4. Go to the EXIT Menu, highlight SAVE CHANGES AND EXIT and hit <ENTER>.
Configuring RAID in the Media Shield BIOS Utility
1. After exiting the BIOS utility, the blade will begin to boot up. At this time press
<F10>. This brings up the M
EDIA SHIELD BIOS UTILITY screen.
2. In the MEDIA SHIELD BIOS UTILITY screen, select either MIRRORED or STRIPED as
your selection for the RAID M
ODE option.
3. For the DISKS selection, use the arrow keys to add drives to the ARRAY section. You
must select and add at least two drives to the A
RRAY section for RAID to work on the
module.
4. Press <F7> to finish.
5. In the confirm message screen that appears press <Y> to confirm your selections.
6. Another confirm screen will appear asking you if you want to “Clear MBR”. Press
<Y> again to confirm this message.
7. Press <C
TRL> + <X> to exit the program.