Superrollo GW70 - Automatic Solar Function; Setting Sensivity

28
EN
The automatic solar function is switched on by setting
or changing the sensitivity. Congure the brightness at
the level which the blinds should be closed.
If you do not intend to use the auto-mated solar func-
tion, it is necessary to remove the solar sensor from the
window pane and protect it from the sunlight or remove
the connector from the GW70 device.
1. + Simultaneously press the buttons.
2. The current brightness is now set as the set limit and
the automatic solar function is activated.
If this value is exceeded, the roller shutters will roll
down to the light sensor.
14.1 Automatic solar function; setting sensivity
i
Set the current brightness as set limit and switch on
the automatic solar function.
3. Pay attention to the sun LED.
OFF
Automatic solar function OFF
ON
Automatic solar function ON
Slowly ashing ...
...if the set limit is exceeded.
Rapid ashing
If the current brightness value is outside
the measuring range, the set limit is set
to the measured range limit..
4. You can switch the automatic solar
function on and o as required.
In order to do so, press and hold the
sun button for approx. 2 seconds.