Installation Instructions
Part #SS450 - Rear Trac Bar
D. Installation of Rod Assembly
Position the rod assembly to the rear of the axle bracket and frame bracket. Install the rod assembly using
the 3/4” bolts, at washers and lock nuts. Be sure that there is a at washer on each side of the urethane
bushing. When adjusting the length of the rod assembly, it is necessary that the coach’s full weight be on
the suspension. Adjust to t with the coach at normal ride height.
E. Torque Specications & Follow-Up
Be sure to check all fasteners for tightness, including the jam nut on the rod assembly. Torque the ¾” rod
end bolt to 130 - 160 ft. lbs. Torque the jam nut to 100 - 150 ft. lbs. This completes the installation.
Test drive. To register your product for warranty purposes, go to the SuperSteer website at
www.SuperSteerParts.com and ll out the online registration card
Re-check torque in 6 months.
Your comments are greatly appreciated.
Please feel free to contact SuperSteer® at
888-898-3281 or e-mail at
Sales@SuperSteerParts.com
A Division
of
To Previous Page
Loading...