Assembly of Trailer Valet (cont.)
5. Use the 4 bolts and 8 washers and lock washers provided to secure to most trailer frames. Place
bolts as close to the frame as possible. Do not completely tighten the bolts yet, it is
recommended that you first ONLY test that the Trailer Valet will have the necessary clearance
to operate and rotate into the stow position.
6. Attach Trailer Valet to the mounting clamp to the vertical position to check height. The Trailer
Valet wheels should be a couple inches off the ground, allowing you to deploy the trailer valet
and jack up the trailer. DO NOT JACK UP OR DRIVE THE TRAILER YET. If this checks, remove the
Trailer Valet and continue to the next point. If not, adjust and test again.
7. Evenly tighten the 4 bolts. Do not over tighten the bolts. Attach the Trailer Valet and set the
stow pin to secure the Trailer Valet and set the cotter pin to secure the stow pin.
8. You are now ready to enjoy your new Trailer Valet, which is at your service anytime.
If you need assistance, please contact customer support.
Trailer Mount Bracket and Trailer Mount Clamp illustration
To Next Page
Loading...
Need help?
General