07. MAINTENANCE INSTRUCTION07. MAINTENANCE INSTRUCTION
Slip and correction of walking belt
Sports suggestions and guidelines
10
11
1. Clean the treadmill
Turn off the machine and unplug the power cord
Apply a mild cleaner to a cotton cloth.
Do not spray the cleaner directly on the walking belt
Do not wipe under the walking belt
2. Walking belt lubrication
Turn off the walking machine and unplug the power cord
Lift the edge of the walking belt and smear the inner surface with silicone oil
Start the walking treadmill and run at 3mph for 10-20 seconds before use
The walking belt should be lubricated every one month
1. When running belt leans to the left, adjusting screw on the left 1-2 turns clockwise. Then,
test running; If the running belt still leans to the left, repeat the above steps until the running
belt is aligned.
2. When running belt leans to the right, adjusting screw on the right 1-2 turns clockwise. Then,
test running; If the running belt still leans to the right,repeat the above steps until the running
belt is aligned.
3. When the running belt gets too tight it will cause stronger resistance. Please adjust both sides
screws 1-2 turns counterclockwise, loosen the belt until stopping skidding or pausing; When the
running belt too loose, please adjust both sides screws 1-2 turns along the clockwise.
To Next Page
Loading...