incorrect, the LED will blink twice and keep being at setup mode (being on). Then
please return to step C.
E. Try if keys on Remote Control work or not. If most keys work improperly, please
try other code under the same brand (For example: code 004,023 …… under
Philips TV), repeat A~E till you find the main keys work good enough.
Remark: In the process of setup, if you want to quit from set up mode, please press the device key.
If no key is pressed in 10 seconds, the remote control will leave the setup mode automatically.
Set up By Manual Search
If you have tried all the codes under the brand name, the remote control still does
not work (i.e. the device still can not be controlled by this remote control), or you can
not find the correct brand in the Device Code List, you can use Manual Search to find
out the correct code.
A. Power on the device that you want to control. If it is a VCR, it must be inserted
with a tape.
B. Press and hold [SET] key and press the device key (TV1 etc) at the same time.
C. The LED will be on at the moment. Then release the pressed keys.
D. Press the [POWER] key again, then release it.The remote control enters into
Manual Search Mode and the LED keeps flashing.
E. Point the remote control to the device, and then press the [POWER] key. See if
the device reacts or not. If it reacts, turn to step F. If not, repeat step E (press the
[POWER]) every 1 second.
F. Test other keys, if they do not work good enough, return to step A.
Remarks:
A. In search process, you can press [SET] key to switch between Forward and Backward to change search
direction and find the right code quickly. If you don’t want to change search direction please don’t press [SET]
key during M anual Search.
B. Whenever you want to leave search mode, press the device key, and the LED will turn off.
C. In the search mode, besides the [POWER] key, all other key’s function can be checked normally. That is to say
you can test other keys without leaving search mode.
D. The URC22D-8, The URC22D-8A, The URC22D-8B unit will leave search mode automatically if no key is
pressed in 30 seconds.
Set Up By Auto Search
This search is similar to Manual Search but the remote control transmit the
power signal automatically instead of manually pressing power key.
A. Power on the device you want to control. If it is a VCR, it must be inserted with a
tape.
B. Press and hold [SET] key, in the meantime, press and hold the Device key (for
To Next Page
Loading...