Sutron 8310 - Page 109

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 109
PwrOnAction Connect
PrimaryIP IP address
SecondaryIP None
MessagePort
CommandPort
RedirectorPort
ServerPassword
CSDShoulderTap No
SMSTxMode None
SMSTxList
SMSAlarmsEnable No
SMSNotifyEnable No
SMSNotifyList
DataPassword
SetupPassword
DataUserList
SetupUserList
ModemAPN
ModemUserName
ModemPassword
ModemPin
RadioBand Quad Mode (default)
RelayUseDigIO No
RelayModule 1
RelayChannel 1
RelayWarmup 0
RelayInvertOutput No
Select outputs ►
End GPRS Menu
Enabled
This property must be set to YES to enable GPRS processing, including self-timed and alarm
transmissions via GPRS and/or SMS communication, and command processing.
TxInterval
The property, along with the TxTime property, determines when transmissions are made. The
units for the rate are HH:MM:SS. Typical rates are 01:00:00 for hourly transmissions and
04:00:00 for transmissions every 4 hours.
TxTime
TxTime is the transmission time assigned to the station. It is used to specify an offset to
TxInterval for transmissions. For example, if TxTime is “00:15:00” while TxInterval is “01:00:00”,
then hourly transmissions will be made at 15 minutes past the hour.
TxFormat
Several formats are supported. Please refer to Appdendix D, Telemetry Formats, for information
on specific formats.
AlarmData
This property helps determine how much data is sent in an alarm transmission. When set to
“AllSensors”, all sensors are included in the transmission and sent as if a self-timed transmisson.
When set to “SensorsInAlarm”, the transmission includes only the sensor(s) triggering the alarm.
(note: the Pseudobinary B, NIFC, and NFDRS formats transmit all data even when
SensorsInAlarm is selected, since decoding those formats depends on the entire content being
present).
PwrOnInterval + PwrOnTime + PwrOnDuration
PwrOnTime, PwrOnInterval, and PwrOnDuration are used to specify when the modem is