Sutron 8310 - Page 113

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 113
and port specified by the command or the primary IP and command port if other
settings were not supplied.
SMSNotifyList
Allows to user to choose what phone numbers get the SMS notification for SMSNotifyEnable’s
events.
SetupPassword and DataPassword
These two properties specify authorization codes used to validate incoming command
messages. SetupPassword specifies the authorization code for “setup-level” access, while
DataPassword specifies the authorization code for “data-level” access. NOTE: To enable SMS
security, local setup and data retrieval users must also be defined.
Incoming command messages have setup-level access by default. When the SetupPassword
property contains an authorization string, any and all incoming messages that normally require
setup-level access to be processed must prefix the command with the authorization code. For
example, to command the station to reboot with an authorization code of “MyAuthCode”, the
incoming message content would be “MyAuthCode reboot”.
SetupUserList and DataUserList
These two properties are authorization settings that require the phone number stated in the
Authlist to be used to validate incoming command messages. Both SetupUserList and
DataUserList are only enabled in addition to the SetupPassword and DataPassword being
enabled.
A better explanation about how it’s used is if the SetupUserList property specifies a phone
number, while SetupPassword is blank, then a user from any phone number can send a setup
command with no code, and the command will be processed. However if SetupUserList property
is blank, while SetupPassword has a code, then the user must have the code, regardless of his
phone number.
For example if he or she wants to send the set TAG VALUE command he or she needs to use the
SetupPassword string, as well send the SMS message with command from the phone number
listed in SetupUserList.
SMS command to send: set stage 3.45
SetupPassword: sutron
SetupUserList: 555-555-5555
Phone used(888-888-8888) & sending the command: sutron set stage 3.45
Stage value is NOT Set on Logger, authorization error logged in system log
Phone used(555-555-5555) & sending the command: sutron set stage 3.45
Stage value is Set on Logger
SMS command processing
If the user wants to change the setup in the GPRS settings or gather status information about
the 8310 from the GPRS modem he or she can use their phone to do it. Alpha shall process the
following commands received via SMS:
Call home (shoulder tap): connect to SSP/CL
-STAP [url[:port]]
Call home with optional IP/Port: connect to redirector port specified