Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 121
To assign an output to a group, change TxContent to “Include”. Sequence determines the order
of the value in the random transmission, and NumVals sets how many values are included in the
transmission for BIN-NONINT format, only. The number of values cannot be set in this dialog if
the Random transmission format is set to BIN-INT.
If you want this output to trigger a random transmission, set TxAlarmMode to “TxIn” and set
DataInterval and DataTime to match the data to include in the transmission (i.e., set them to
match the measurement schedule of the output, or some multiple, thereof).
Station Setup/Communications/COMx Modem
The settings for Modem are the same as for Voice except it does not have the following fields:
AnswerMode – answer mode is always data
Language – language only needed for voice
DialInMsg, DialOutMsg – only needed for voice.
Station Setup/Communications/COMx Voice
Sutron’s voice modem is capable of both data and voice communications. The settings for the
voice modem are as follows:
Voice COM4:
Enabled No
BaudRate 115200
MasterID BASE
AnswerMode Data
RingToAnswer 2
Language English
PhoneNumber1
PhoneNumber2
PhoneNumber3
PhoneNumber4
PhoneNumber5
PhoneNumber6
PhoneNumber7
PhoneNumber8
PhoneNumber9
PhoneNumber10
RedialDelay 00:01:00
NumRedials 3
DialInMsg
DialOutMsg
SSP Settings
End Voice COM4:
To Next Page
Loading...
