Sutron 8310 - Page 139

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 139
Message
Num chars = 0 Num secs = 0.0
Send to Sutron
Satellite ID
Channel
Type
Send to Sutron
Satlink Status
Clear status
Reset Failsafe
Reset Satlink
Set factory defaults
End Satlink COMx Test
See the following table for descriptions of each function:
SelfTimed message
Shows the current self-timed message, its size (number of
bytes), and its length in seconds (i.e., the number of
seconds the Satlink device will be on “air”, occupying the
designated channel space).
Random message
Shows the current random message, its size (number of
bytes), and its length in seconds (i.e., the number of
seconds the Satlink device will be on “air”, occupying the
designated channel space).
Send to Sutron
This menu gives the ability to send a test message to Sutron
using Satlink.Contact Sutron customer service for assistance
in using this feature.
Satlink Status
When you press RIGHT or SET on this menu item, the
system retrieves the current status message from Satlink,
and diplays it one line at a time. This message is usually
quite long. Once the message is displayed, press DOWN
and/or UP to move through the message for reading. Press
CANCEL to stop navigating through the message, and return
to the menu.
Clear Status
Use this menu item to command the Satlink device to clear
its status data (counts, errors, etc.).
Reset Failsafe
Use to command Satlink to reset its failsafe.
Reset Satlink
Use to reset the Satlink device
Set factory defaults
Use to command Satlink to reset all of its settings to factory
defaults.
Iridium COMx: Test
The Iridium diagnostic menu follows:
Modem status Standby-Off
Next task Nothing
Next task time None
Last ST tx None
Total ST tx 0