Sutron 8310 - Supported Commands List

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 230
The following table describes the supported commands. The “Access Level” column specifies the user access
levels that may issue the command. For example, if “Setup” is the only access level listed for a particular
command, then only users having Setup access may issue the command.
Command
Description
Access Level
ABOUT
Shows information about the programs running in
the 8310
Setup&Data
CAL sensor data
Performs a single point calibration adjusting the
sensor’s calibration offset such that data will become
the sensor’s future value. The sensor name is
specified using the measurement number and input
number (ie: “M1.I1”). Calibration data is stored in
the registry apart from the setup and hence will be
retained even if a new setup is loaded.
Setup
CD path
Change directory
Setup&Data
COPY src dest
Copy a file. A wildcard * character may be used as
part of the src to match one or more files, but then
dest should contain the name of a folder. If a path
contains spaces it must be surrounded in double
quotes.
ex: copy “\usb card\*.*” “\flash disk\”
Setup
DATE [mm-dd-yyyy]
Displays or sets the date
Setup (when
changing
date)
Date (when
viewing date)
DEFAULT
Exits and runs \Windows\Remote COM1:115200
Setup
DEL file
Delete file
Setup
DIR path
Display directory
Setup&Data