Suzuki GSF1250 - Page 602

5C-9 Clutch:
Assembly
Assemble the master cylinder in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Wash the master cylinder components with
new brake fluid before reassembly.
• Do not wipe the clutch fluid off after
washing the components.
• When washing the components, use the
specified clutch fluid (Brake fluid). Never
use different types of fluid or cleaning
solvents such as gasoline, kerosine, etc.
• Apply brake fluid to the master cylinder
bore and to all of the master cylinder
components to be inserted into the bore.
BF: Brake fluid (DOT 4)
• Apply SUZUKI SILICONE GREASE to the push rod
end.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
• When installing the clutch lever position switch, align
the projection on the switch with the hole in the master
cylinder.
• Apply SUZUKI SILICONE GREASE to the clutch lever
pivot bolt when installing.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
Tightening torque
Clutch lever pivot bolt: 6.0 N·m (0.6 kgf-m, 4.5 lb-
ft)
Clutch lever pivot bolt lock-nut: 6.0 N·m (0.6 kgf-
m, 4.5 lb-ft)
I649G1530016-02
I649G1530017-03
I649G1530018-02
I718H1530069-01