6-36 ELECTRICAL SYSTEM
OIL PRESSURE INDICATOR INSPECTION
• Remove the signal generator cover. (!3-13)
• Disconnect the oil pressure Green/Yellow lead wire from the oil
pressure switch.
• Turn the ignition switch to the “ON” position.
• Check if the oil pressure indicator lights up when grounding the
Green/Yellow lead wire.
If the oil pressure indicator does not light up, check the couplers.
If all of the connections are OK, replace the oil pressure indicator
with a new one. (!3-16 and 37)
• After checking the oil pressure indicator light, install the signal
generator cover. (!3-46)
G/Y
To oil
presure
switch
ON
To Next Page
Loading...
