GSF600Y (2000-MODEL) 8-5
• Remove the combination meter 4 by removing the two bolts.
• Remove the headlight housing bracket 5 by removing the front
fork. (!5-13)
• Reassemble and remount the combination meter in the re-
verse order of removal and disassembly.
DISASSEMBLY
• Disassemble the combination meter as follows.
INSPECTION
Measure the continuity between the lead wires in the diagram on
the next page using a tester.
If there is no continuity, replace the combination meter assy.
NOTE:
When performing this test, it is not necessary to remove the com-
bination meter.
To Next Page
Loading...
