ENGINE 3-19
GEARSHIFT
• Remove the circlip and washer from the gearshift shaft.
) 09900-06107: Snap ring pliers
• Draw out the gearshift shaft
1, and then remove the gearshift
cam driven gear
2.
NOTE:
When removing the gearshift cam driven gear, do not lose the
gearshifting pawl
3, pin
4 and spring
5.
OIL PUMP DRIVEN GEAR
• Remove the circlip
1.
) 09900-06107: Snap ring pliers
• Remove the washers
2, oil pump driven gear
3 and pin
4.
NOTE:
Be careful not to drop the circlip, pin and washers into the oil
pan.
STARTER CLUTCH
• Remove the starter idle gear
1 and its shaft
2.
To Next Page
Loading...
