3-20 ENGINE
• Hold the starter clutch assembly using the special tool and
then loosen the starter clutch mounting bolt.
) 09920-34810: Starter clutch holder
NOTE:
Do not remove the starter clutch mounting bolt at this stage, only
loosen it. You will need to use it in conjunction with the special
tool when removing the starter clutch assembly.
• Remove the starter clutch assembly
3 from the crankshaft
using the special tool.
) 09930-33720: Rotor remover
GEAR POSITION SWITCH
• Flatten the tab on the oil seal retainer and remove the bolt.
• Remove the oil seal retainer
1.
• Remove the gear position switch
2.
• Remove the O-ring
3, switch contact
4 and spring
5.
NOTE:
Do not lose the O-ring, switch contact and spring.
To Next Page
Loading...
