ENGINE 3-17
CLUTCH
• Remove the clutch cover 1.
• Remove the dowel pins and gasket.
• Hold the clutch housing with the special tool.
09920-53740: Clutch sleeve hub holder
• Remove the clutch springs.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
• Remove the pressure plate 2
• Remove the clutch drive plates and driven plates.
• Remove the spring washer 3 and washer 4.
• Remove the clutch push piece 5, bearing 6 and thrust
washer 7.
Do not damage the clutch plates by the special tool.
To Next Page
Loading...
