CHASSIS 8-57
• Remove the rear fender (lower) .
• Remove the chain case .
• Remove the chain buffer .
SWINGARM PIVOT BOSS REMOVAL AND INSTALLATION
• Remove the swingarm. (8-56)
• Remove the swingarm pivot boss nut .
NOTE:
Remove the swingarm pivot boss when only replacing it.
• Remove the swingarm pivot boss by removing its set
screws.
• Set the swingarm pivot boss by its set screws.
• Tighten the swingarm boss nut to the specified torque.
" Swingarm pivot boss nut: 65 N·m (6.5 kgf-m, 47.0 lb-ft)
To Next Page
Loading...
