Suzuki LT-A400 - Drive Bevel Gear Removal and Installation (LT-F400

Propeller Shafts: 3D-15
• After the backlash and tooth contact have been
checked or adjusted, stake the nut with a center
punch.
Drive Bevel Gear Removal and Installation (LT-
F400/F)
B827H13406022
Removal
1) Remove the engine assembly from the frame. Refer
to “Engine Assembly Removal in Section 1D
(Page 1D-6)”.
2) Remove the engine top side. Refer to “Engine Top
Side Disassembly in Section 1D (Page 1D-10)”.
3) Separate the crankcase. Refer to “Engine Bottom
Side Disassembly in Section 1D (Page 1D-34)”.
4) Using a chisel, unlock the nut.
5) Hold the output shaft with the special tool and a vice.
Special tool
(A): 09930–73190 (Output shaft holder)
6) Remove the drive bevel gear nut.
7) Remove the washer (1) and drive bevel gear (2).
8) Remove the shim (3).
9) Remove the transfer output shaft (4) with a plastic
mallet.
Installation
Install the drive bevel gear in the reverse order of
removal. Pay attention to the following points:
NOTE
Apply engine oil to each rotating part before
reassembling.
• Install the transfer output shaft assembly (1) with a
plastic mallet.
I827H1340069-01
I827H1340070-01
(A)
I827H1340071-01
1
2
3
I827H1340072-01
4
I827H1340073-01
1
I827H1340074-01