6-3
IGNITION SYSTEM CHECK
1. Remove the spark plug and reat-
tach it to the spark plug lead.
2. Put the engine stop switch in the
“” position and ignition switch in
the “ON” position. While holding
the spark plug base firmly against
the engine, pull the recoil starter
rope or push the electric starter
button. If the ignition system is
operating properly, a blue spark
should jump across the spark plug
gap. If there is no spark, take your
machine to your authorized
Suzuki dealer.
COMPLAINT: Engine stalls
1. Make sure there is enough fuel in
the fuel tank.
2. Check to see that the spark plug
is not fouled. Remove the plug
and clean it. Replace it, if neces-
sary.
3. Make sure the fuel valve is not
clogged. Also check to be sure the
air vent hose connected to the fuel
tank is not clogged.
4. Check the idle speed. If neces-
sary, adjust it using a tachometer.
The correct idle speed is 1400 –
1600 r/min.
WARNING
Performing the spark test improp-
erly can be hazardous.
You could get a high voltage elec-
trical shock if you are not familiar
with this procedure.
Do not perform this check if you
are not familiar with the proce-
dure. Do not point the spark plug
near the spark plug hole during
this test. Do not do this test if you
have a heart condition or wear a
pacemaker.
To Next Page
Loading...
