Suzuki LT-A750X/P - Front Hub Bearing Inspection; Front Hub Bearing Removal and Installation

2B-7 Front Suspension:
• Install the brake caliper. Refer to “Front Brake Caliper
Removal and Installation in Section 4B (Page 4B-3)”.
• Install the front wheel assembly. Refer to “Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-2)”.
• Tighten the front hub nut (13) to the specified torque.
Tightening torque
Front hub nut (d): 110 N·m (11.0 kgf-m, 79.5 lb-ft)
• Install the cotter pin (14).
CAUTION
!
The removed cotter pin (14) must be replaced
with a new one.
Front Hub Bearing Inspection
B831G22206008
Inspect the inner race play of the front hub bearing by
hand while they are in the steering knuckle.
Rotate the inner races by hand to inspect for abnormal
noise and smooth rotation. If there is anything unusual,
replace the front hub bearing with a new one.
Front Hub Bearing Removal and Installation
B831G22206009
Refer to “Front Wheel Hub / Steering Knuckle Removal
and Installation (Page 2B-4)”.
Removal
1) Remove the outer dust seal (1) with the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
2) Remove the snap ring (2) with the special tool.
Special tool
: 09900–06108 (Snap ring pliers)
3) Remove the inner dust seal (3) with the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
“a”: Play
14
(d)
13
I831G1220023-02
“a”
“a”
I831G1220024-02
(A)
1
I831G1220025-03
2
I831G1220026-02
3
(A)
I831G1220027-02