Suzuki LT-A750X/P - Specifications; Service Data; Special Tools and Equipment; Recommended Service Material

3C-18 Transfer:
Specifications
Service Data
B831G23307001
Drive Train
Unit: mm (in) Except ratio
Special Tools and Equipment
Recommended Service Material
B831G23308001
NOTE
Required service material is also described in the following.
“Transfer Components (Page 3C-2)”
“Gearshift Cam Components (Page 3C-9)”
Special Tool
B831G23308002
Item Standard Limit
Primary reduction ratio (Automatic
drive)
Variable change (2.763 – 0.780) —
Secondary reduction ratio 2.158 (40/21 x 17/15) —
Final reduction
ratio
Front 3.600 (36/10) —
Rear 3.600 (36/10) —
Transfer gear
ratio
Low 2.562 (41/16) —
High 1.240 (31/25) —
Reverse 1.882 (32/17) —
Shift fork to
groove clearance
Low 0.10 – 0.30 (0.0040 – 0.0120) 0.50 (0.020)
High 0.10 – 0.30 (0.0040 – 0.0120) 0.50 (0.020)
Reverse 0.10 – 0.30 (0.0040 – 0.0120) 0.50 (0.020)
Shift fork groove
width
Low 5.50 – 5.60 (0.217 – 0.220) —
High 5.50 – 5.60 (0.217 – 0.220) —
Reverse 5.50 – 5.60 (0.217 – 0.220) —
Shift fork
thickness
Low 5.30 – 5.40 (0.209 – 0.213) —
High 5.30 – 5.40 (0.209 – 0.213) —
Reverse 5.30 – 5.40 (0.209 – 0.213) —
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 3C-14)
09900–06107 09900–20102
Snap ring pliers Vernier calipers (1/20 mm,
200 mm)
)(Page 3C-3) / )(Page 3C-
11) / )(Page 3C-11) /
)(Page 3C-11) /
)(Page 3C-15)
)(Page 3C-13) /
)(Page 3C-13)
09900–20803 09920–13120
Thickness gauge Crankcase separating tool
)(Page 3C-12) )(Page 3C-3)