3-7
BREAK-IN
The first month is the most impor-
tant in the life of your vehicle.
Proper operation during this
break-in period will help assure
maximum life and performance
from your new vehicle. The follow-
ing guidelines explain proper
break-in procedures.
Maximum Throttle Opening
Recommendation
During the first 10 hours of opera-
tion, you should always use less
than 1/2 throttle.
Vary the Engine Speed
Vary the engine speed during the
break-in period. This allows the
parts to “load” (aiding the mating
process) and then “unload”
(allowing the parts to cool).
Although it is essential to place
some stress on the engine com-
ponents during break-in, you must
be careful not to load the engine
too much.
Avoid Constant Low Speed
Operating the engine at constant
low speed (light load) can cause
parts to glaze and not seat prop-
erly. Allow the engine to acceler-
ate freely through the gears,
without exceeding the maximum
recommended throttle opening.
Allow the Engine Oil to
Circulate Before Riding
Allow enough idling time after
warm or cold engine starting
before revving the engine or plac-
ing the transmission in gear. This
allows time for the lubricating oil
to reach all critical engine compo-
nents.
Observe Your Initial and Most
Critical Service
The initial service (break-in main-
tenance) is the most important
service your vehicle will receive.
During break-in operation, all of
the engine components will have
mated together and seated. Main-
tenance required as part of the
initial service includes correction
of all adjustments, tightening of all
fasteners and replacement of dirty
oil. Timely performance of this
service will help make sure you
get the best service life and per-
formance from the engine.
WARNING
Indicates a potential hazard
that could result in injury or
death.
To Next Page
Loading...
