COOLING AND LUBRICATION SYSTEM 6-7
COOLING FAN
REMOVAL
• Remove the front fender. (# 7-6)
• Drain engine coolant. (#6-4)
• Remove the radiator. (#6-4)
• Remove the cooling fan.
• Remove the cooling fan motor.
INSPECTION
• Remove the radiator cap lid.
• Disconnect the cooling fan motor lead wire coupler
1.
• Test the cooling fan motor for load current with an ammeter
connected as shown in the illustration.
• The voltmeter is for making sure that the battery applies 12
volts to the motor. With the motor with electric motor fan run-
ning at full speed, the ammeter should be indicating not more
than 5 amperes.
• If the fan motor does not turn, replace the motor assembly
with a new one.
NOTE:
When making above test, it is not necessary to remove the cool-
ing fan.
Fan motor Ammeter
Battery
To Next Page
Loading...
