93
25
21
55
38
3:
2:5
2:5
0:30
0.
0.
0.
0.33
4
8
8
66
22
1400
1400
1400
1400
1400
1400
800
4.5
2.5
:
:
.
2.
1
0
1400
1400
9
9
1
Wash and Dry
full load
Wash and Dry
half load
5.0
5
5
53.00
53.00
45.00
55.00
1.0
0.0
[[[[[[[;;;;;;;;$
.5
38
:0
:
:
Dry fault
Check whether the drying clothes are excessive (refer to
the program table and check corresponding capacity of
the program), and take out part of the clothes to dry
again.
Clothes are not fully dewatered (refer to the
treatment of bad dehydrated effect in the manual).
Fault phenomenon
Recommended processing method
Washing machine
does not carry out
dry process
Dry is not sufficient
Dry fault
Dry time is too long
Check whether the dry program is set up.
Check whether the water tap is unopened.
Check whether the door is well closed.
Check whether the dry clothes are excessive (refer to the
program table and check corresponding capacity of the
program), and take out part of the clothes to dry again.
Check whether the dry clothes are excessive. If so, it
will cause unsatisfactory dry effects and folds in clothes.
Please divide the clothes in the drum into two parts for
drying separately.
Check whether the clothes (such as thicker cotton, etc.)
that are not easy to dry are mixed with the clothes that
easy to dry (such as chemical fiber, etc.). Please dry the
clothes of different types separately or dry them again.
More thicker clothes (denim, etc.).
Programme Instructions
1.The eco 40-60 programme is able tP clean normally soiled cotton laundry declared to be washable about
40℃ to 60℃, together in the same cycle,and that this programme is used to assess the compliance with
the EU ecodesign legislation.
2.The power consumption ofthe off-mode is 0.49W,and the left-on mode is 0.49W.
3.The most efficient programmes in terms ofenergy consumption are generally those that perform at
lower temperatures and longer duration.
4.Loading the household washing machine or the household washer-dryer up to the capacity indicated
by the manufacturer for the respective programmes will contribute to energy and water savings.
5. Correct use of detergent, softeners and other additives. Do not apply excessive detergent. This may
aect the washing results adversely.
6.Periodic cleaning,including optimal frequency, and limescale prevention and procedure
7.Noise andremainingmoisturecontent are influenced bythe spinning speed: the higher the spinning
speed in the spinning phase, the higher the noise and theglower the remainin moisture content.
8.Theproduct information andthe energyconsumption label, the product registration information can be
obtained by scanning the QR code.
9. The information of standard programmes
10.The wash anddrycycle is able toclean normally soiled cotton laundry declared to be washable at 40℃
or 60℃,together in the samecycle,andto dry it in such a way that it can be immediately stored in a
cupboard,and that this programme is used to assess the compliance with the EU ecodesign legislation.
To Next Page
Loading...