B. Install the Oven
1. Fix ADJSUT SCREW on the UPPER AIR TUNNEL of the oven, and then
ins
tall the oven into the cabinet.
Adjust the height of ADJUST SCREW to keep 1mm gap between the
ADJUST SCREW and the top plane of cabinet.
Do not trap or kink the power cord.
Make sure that the oven is installed in the center of the cabinet.
2.
Open the door; fix the oven to the cabinet with SCREW at the
INS
TALLATION HOLE of TRIM KIT. Then fix the TRIM-KIT PLASTIC COVER
to
the INSTALLATION HOLE.
TRIM-KIT
UPPER AIR TUNNEL
ADJUST SCREW
ADJUST HEIGHT
ADJUST SCREW
TRIM KIT
SCREW
TRIM-KIT PLASTIC COVER
INSTALLATION HOLE
To Next Page
