18
ELECTRIC AND GAS CONNECTION WARNINGS :
• Device adjustment conditions are on the label under the hob.
• Keep the natural ventilation wholes and make compulsory ventilation system
established.
• Device electric connections must be connected to the fuse according to its amper
value. Contact with authorised services for this issue.
• This device is produced to be used with 220-240V , 50-60Hz. If electrıc network is
different then this contact with authorised service.
• The electric network must be grounded , otherwise producer company is not
responsible for the damages may ocur.
• Avoid touching device power cable to hot areas of the device.
• If power cord has any kind of damage , contact with authorised service immediately.
Do not try to change by yourself. You you cause gas leakage due to wrong disassemble.
• The warmth will go on right after the usage of device even it is turned off. Not to cause
an accident avoid from the children.
• The hood pressure must be 30mbar which will be used for connection of LPG and your
gas hob.
• Place the hose coming from LPG until the end of gas hob gas inlet then squeeze with
metal clamp.
• LPG hose must be turned with wide angle due to the risk of breaking. Do never tie the
hose with rope or plastic clamp to eachother due to being longer.
• Moving a device after gas connection is done may cause gas leakage.
• For CNG connection contact with authorised service.
• Moving a device after gas connection is done may cause gas leakage.
• Fors a safe gas connection your hose must be minimum 40cm maximum 125cm
length.
• Do not control gas leakage never with a flammable devide ( cigarette, matches,lighter
etc) Instead of this use soap bubble / foam. If there is gas leakage you will see bubbles
are getting larger.
• When you finish with device do not forget to turn off gas valves and main valve.
• At the first usage of hot plate there might be some smoke and smell , this is normal and
there is no problem.
• While the device (hot plate or gas burners ) is working do not interfere with cold water.
The hot vapour arising from hot surface may injure you.
• While cooking with oil due to being over heating , the oil may cath fire. At this point do
never interfere with water. Oil grains will combine water vapour and spread flame to
every direction, and this may cause a large fire.
To Next Page
Loading...