SERVICE MANUAL
ENGLISH
Installation Specifications for Overseas Electric Water Heater
I. Preparation before installation
(I) Installation tools
1. Percussion drill
(Used to punch through wall hole to install and fasten host machine and pipeline)
2. Hammer
(Used to knock properly for installation of plastic expanding tube)
3. Adjustable wrench
(Used to install fastening screws)
4. Screwdriver
(Used to install fastening screws)
5. Tubing cutter or hacksaw
⟶ཱྀᩚ圆器
⟶
简易
⟶
ཱྀᩚ圆器
⨺
ゅ锤
࿈
ᱵ୩⏝ᢆᡭ
轻
型
管
剪
or (Used to cut and cut off all pipe fittings)
6. Round-making device
(Used for calibration and round-making of plastic tubes, convenient for jacketing of
pipe fittings)
7. Hot-melt machine
(Used for heat-up fusing connection of thermoplastic plastics pipe workpiece)
8. Cramp
(Sharp-nose pliers, used for cutting off steel wire rope and wire stripping)
9. Paintbrush
To Next Page
Loading...
