ENG
10
5.1 Active Home Theater
Speaker System
• If preset stations are available in the memory, you can switch from one to another by short
pressing buttons , on the front panel or buttons e and t on the remote control. The station
frequency can also be entered with the numeric pad buttons. The radio will tune to the set frequency
within 2-3 seconds.
Clock Mode
• When the HTSS is in the ST.BY mode, the display a shows the current time. When the system is
in a diԚerent mode, to see the time use the CLOCK s button on the remote control. The current
time will be displayed for 3-5 seconds.
• To set the current time, go to the ST.BY mode by pressing button e on the front panel or button
o on the remote control long. To enter the time setting mode, press the SET c button on the
remote control (the corresponding position will start blinking on the display a). Set the minutes
and hours directly from the RC numeric pad or using buttons c and f on the front panel or buttons e
and t on the RC. Press the SET c button short to switch between setting hours/minutes and to
exit the setting mode.
ST-BY Mode
• To enter/exit this mode, press and hold down button e on the front panel or button o on the
RC. When the HTSS is in the ST-BY mode, the display a shows the current time.
Audio setting reset
• Press the button RESET on the remote control to reset audio settings.
ǃǤǜǠǙǫǔǡǜdz:
• If the MSS is left unused for a long period of time, mind to switch it off with the POWER
switch (m, OFF position) and unplug the power cord o from the mains socket.
• To improve the sound quality, use the Line-Out port of your sound card.
26
To Next Page