Swann Wireless door chime - Operating Basics; Adjusting Chime Volume; Changing Chime Sounds; Pairing Doorbell and Chime

OPERATING BASICS
Adjusting volume
Changing chimes
Pairing with the Chime Speaker
Resetting the Chime Speaker
Decrease or increase the
volume of the Chime Speaker
Make sure the chime is
not playing then press
and hold this button
for 5 seconds. You
will hear the current
chime playing followed
by a double beep.
Switch the power point
off and unplug the
Chime Speaker.
Press and hold this button. While
holding the button, plug the Chime
Speaker back in and switch the
power point on. Keep holding the
button until the Chime Speaker
blinks twice. After you reset the
Chime Speaker, you need to pair
the Doorbell again.
Press the Doorbell button
within 10 seconds.
The Chime Speaker beeps
once to confirm successful
pairing. The pairing process
ends when you hear a
double beep.
Cycle through the sounds available on the Chime Speaker.
Stop when you hear something you like.
There is no need to confirm your selection.
If the Doorbell is not paired, here's how you can easily pair it with the Chime Speaker.
1
1
2
2