To Next PageTo Next Page
Need help?Do you have a question about the SWEED MACHINERY 510AF-AH and is the answer not in the manual?
General| Brand | SWEED MACHINERY |
|---|---|
| Model | 510AF-AH |
| Category | Food Processor |
| Language | English |
Procedure for pressing the bearing race into the face plate bore, ensuring proper seating against the shoulder.
Steps to install the bearing seal into the face plate bore, with the seal cup facing the bearing race.
Instructions for cleaning the knife pocket and installing the shim for proper seating of the stationary knife.
Guide for pressing the bearing race into the rear plate bore, ensuring correct alignment and seating.
Process for inserting the bearing seal into the rear plate bore until it is flush with the surface.
Detailed steps for assembling the rotating knife holder onto the shaft using a key and anti-seize compound.
Instructions for installing the spacer plate, ensuring its notch aligns with the knife holder's pocket.
Procedure for installing the rotating knife, torquing bolts, and seating the knife properly in its pocket.
Steps for aligning and installing the face plate, including torquing the mounting screws to specifications.
Guide for cleaning the knife pocket and installing the stationary knife, ensuring proper seating and torque.
Instructions for inserting the rotating knife holder assembly and installing the rear plate, including torquing bolts.
Procedure for installing the rear bearing onto the shaft and into the race, followed by the bearing seal.
Steps to install the rear preload spacer into the seal and hand-tighten the lock nut.
Comprehensive guide for installing the front bearing, feedworks side oil seal, preload spacer, and lock nut.
Detailed procedure for adjusting the knife gap by tightening lock nuts, ensuring proper clearance between knives.
Instructions for securing the front and rear lock nuts by bending the lock washer tab into the nut slot.
Procedure for installing the material guide, ensuring it rests against the stationary knife and is properly secured.
Steps for supporting and installing the flywheel and QD hub, ensuring correct positioning and tightening torque.
